CCNP Switch 300-115 Dumps PDF

Planning, configuring, and verifying the implementation of complex enterprise switching solutions topics are well explained in Cisco 300-115 exam braindumps of DumpsSchool.

Try it Latest DumpsSchool 300-115 Exam dumps. Buy Full File here: (598 As Dumps)

Download the DumpsSchool 300-115 braindumps from Google Drive: (FREE VERSION!!!)

Question No. 1

Which two statements about 802. 1q are true? (Choose two )

Answer: B, E

Question No. 2

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.

* DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105

* DSW2 – primary device for VLAN 103 and VLAN 104

* A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.

Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.

What is the priority value of the VLAN 105 HSRP group on DSW2?

Answer: B

Question No. 3

Which HSRP feature allows a router to take over as the active router when it is configured with a higher priority?

Answer: D

Question No. 4

A network is running VTPv2. After verifying all VTP settings, the network engineer notices that the new switch is not receiving the list of VLANs from the server. Which action resolves this problem?

Answer: D

Question No. 5

Which virtual MAC address does HSRP group 37 use with default configuration?

Answer: B

Question No. 6

What does the command vlan dot1q tag native accomplish when configured under global configuration?

Answer: D

Question No. 7

When a private VLAN is configured, which mode must be configured as a router facing port?

Answer: B

Question No. 8

Refer to the exhibit.

A network engineer investigates a recent network failure and notices that one of the interfaces on the switch is still down. What is causing the line protocol on this interface to be shown as down?

Answer: C

Question No. 9

Which two tasks must you perform to correctly configure IP Source Guard on a switch? (Choose two)

Answer: D, E

Question No. 10

Refer to the exhibit.

You have applied this configuration to Switches A, B, C, and D, and the switches are connected to one another on access ports. Which two additional actions must you take to enable the hosts on VLAN 3 to communicate with one another considering future growth with hosts on additional VLANs? (Choose two.)

Answer: A, E

Question No. 11

Which switchport feature will block the packet with unknown MAC address from sending it via port.

Answer: B

Question No. 12

Refer to the exhibit.

A multilayer switch has been configured to send and receive encapsulated and tagged frames. VLAN 2013 on the multilayer switch is configured as the native VLAN. Which option is the cause of the spanning-tree error?

Answer: C

Question No. 13

Refer to the exhibit.

Which two commands ensure that dsw1 becomes root bridge for vlan 10 ?

Answer: B, D

Question No. 14

The behavior of VLAN 1 BPDUs in a situation where the Native VLAN configured as VLAN 99

and the Native VLAN is Tagged?

Answer: A, D

Question No. 15

What is the maximum number of virtual MAC addresses that GLBP allows per group?

Answer: B

Question No. 16

Which statement about configuring an RSPAN session is true?

Answer: B

300-115 Dumps Google Drive: (Limited Version!!!)

Vendor: Cisco dumps