VCE BrainDumps

Question No. 1

Which statement about VLAN configuration is true?

• A. The switch must be in config-vlan mode before you configure an extended VLAN.
• B. Dynamic inter-VLAN routing is supported on VLAN 2 through VLAN 4064.
• C. A switch in VTP transparent mode saves the VLAN database to the running configuration only.
• D. The switch must be in VTP server or transparent mode before you configure a VLAN.

Question No. 2

Which WAN technology is secure and encrypted by default?

• A. VPN
• B. VSAT
• C. DSL
• D. MPLS

Question No. 3

Which networking function occurs on the data plane?

• A. forwarding remote client/server traffic
• B. sending and receiving OSPF Hello packets
• C. spanning-tree election
• D. processing inbound SSH management traffic

Question No. 4

Which statement about the IP SLAs ICMP Echo operation is true?

• A. It is configured in enable mode.
• B. It is used to determine the one-way delay between devices.
• C. It is used to identify the best source interface from which to send traffic to a destination.
• D. The frequency of the operation is specified in milliseconds.

Question No. 5

If primary and secondary root switches with priority 16384 both experience catastrophic losses, which tertiary

switch can take over?

• A. a switch with priority 20480
• B. a switch with priority 8192
• C. a switch with priority 4096
• D. a switch with priority 12288

Question No. 6

SIMULATION

Lab Simulation Question: 300

CCNA.com has a small network that is using EIGRP as its IGP. All routers should be running an EIGRP AS

number 12. Router MGT is also running static routing to the ISP.

CCNA.com has recently adding the ENG router. Currently, the ENG router does not have connectivity to the

ISP router. All other interconnectivity and Internet access for the existing locations of the company are working

properly.

The task is to identify the fault(s) and correct the router configuration(s) to provide full connectivity between

the routers.

Access to the router CLI can be gained by clicking on the appropriate host.

All passwords on all routers are cisco.

IP addresses are listed in the chart below.

MGT

Fa0/0-192.168.77.33

S1/0-198.0.18.6

S0/0-192.168.27.9

S0/1-192.168.50.21

ENG

Fa0/0-192.168.77.34

Fa1/0-192.168.12.17

Fa0/1-192.168.12.1

Parts1

Fa0/0-192.168.12.33

Fa0/1-192.168.12.49

S0/0-192.168.27.10

Parts2

Fa0/0-192.168.12.65

Fa0/1-192.168.12.81

S0/1-192.168.50.22

• A. First we should check the configuration of the ENG Router.
• B. First we should check the configuration of the ENG Router.

Question No. 7

Which statement about GRE tunnels is true?

• A. They pass clear-text traffic.
• B. They are stateful.
• C. They are unable to carry multicast traffic.
• D. They use MD5 for encryption.

Question No. 8

Which VLAN bridge priority value will make a switch as root for a given VLAN from the below options by the spanning-tree vlan vlan-id root command?

• A. 16384
• B. 8192
• C. 28672
• D. 32768

Question No. 9

Which feature would prevent a workstation from receiving a DHCP address?

• A. STP
• B. 802.1Q
• C. VTP
• D. DTP

Question No. 10

Routers R1 and R2 are on the same network segment, and both routers use interface Ethernet0/0. If R1 loses communication to R2, which two terns should you check as you begn GigabitEthernetO/0. If R1 lose: troubleshooting? (Choose two )

• A. Verify that R2 is using 802 1q encapsulation
• B. Verify that the GigabrtEthernet0/0 interfaces on R1 and R2 are configured with the same subnet mask.
• C. Verify that the R1 GigabitEthernet0/0 interface is up and the line protocol is down.
• D. Verify that R1 and R2 both are using HDLC encapsulation
• E. that the R1 GigabitEthernet0/0 interface is up and the line protocol is up.