VCE BrainDumps

Question No. 1

At which two networks points is route summarization supported? (Choose two)

• A. At EIGRP AS boundaries
• B. At EIGRP interface boundaries
• C. At OSPF virtual-link boundaries
• D. At EIGRP are boundaries
• E. At OSPF area boundaries
• F. At EIGRP stub interface boundaries

Question No. 2

Which reason prevents a designer from using a GDOI-based VPN to secure traffic that traverses the Internet?

• A. Enterprise host IP addresses are typically not routable.
• B. GDOI is less secure than traditional IPsec.
• C. Network address translation functions interfere with tunnel header preservation.
• D. The use of public addresses is not supported with GDOI.

Question No. 3

Refer to the exhibit.

Which data format is used in this REST API call?

• A. JSON
• B. HTMLv5
• C. HTML
• D. XML
• E. BASH

Question No. 4

What is a design benefit of PortFast?

• A. PortFast allows small, unmanaged switches to be plugged into ports of access switches without risking switch loops
• B. PortFast disables spanning-tree on the port, which puts the port into the forwarding state immediately after it is connected
• C. Portfast does not generate a spanning-tree topology change when a station on a port is connected or disconnected
• D. PortFast detects one-way communications on the physical port, when prevents switch loops
• E. PortFast prevents switched traffic from traversing suboptimal paths on the network
• F. PortFast prevents switch loops that are caused by a unidirectional point-to-point link condition on Rapid PVST+ and MST

Question No. 5

Which option describes the fundamental design differences between an IP-based network design and a SAN-based?

• A. An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses redundancy from a dual-attached host, which uses separate fabrics and has very little east-west traffic
• B. An IP-based design has redundancy from the host and high amounts of east-west traffic, whereas a SAN-based design uses redundancy in the fabric and very little east-west traffic
• C. An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses zoning based redundancy which uses separate fabrics and has very little east-west traffic
• D. An IP-based design has redundant connectivity in the fabric and very little east-west traffic, whereas a SAN-based design uses redundancy in the host, which uses separate fabrics and has high amounts of east-west traffic